A-Z Manufacturers (ASSA ABLOY Entrance Systems Ltd - Industrial) |  CAWS Index

View larger image of Crawford 242 Glazed Overhead Sectional Door from ASSA ABLOY Entrance Systems Ltd - IndustrialCrawford OH1042F Glazed Overhead Sectional Door

A glazed sectional overhead door, designed to be used when there is a need for light, exposure, or vision. Typical applications are show-rooms, fire stations, or other applications where optimal daylight inlet and/ or exposure possibilities are desirable.The sectional door slides up under the roof when opened, allowing free space around the door opening and leaving it completely free.The glazed sections are made of extruded, anodised or painted aluminium and are equipped with single or double acrylic windows (frosted or tinted) or hardened glass.The frames are available in anodised aluminium as standard.Size:Maximum:7250 x 6050 mm. On request available up to 9000 x 6050 mm.Arrangement: Size (width x height): Insert details.Shot blasted counterbalance springs, mounted on a galvanized, hexagonal shaft.Spring and cable break anti-drop devices.Flush hinges and roller brackets.Inset lifting handle.EPDM perimeter and horizontal joint seals.Finger pinch protection to horizontal joints. Door panels: 44 mm thick, 600 mm deep sections constructed from horizontal and vertical aluminium glazing bars.Ironmongery:Internal sliding shootbolt suitable for additional padlock with interlocked micro switch to prevent motor and door damage.Performance: EN 12424 Wind resistance Class 2 – minimum 700 N/m².EN 12425 Water penetration Class 3 – 70 Pa resistance.EN 12426 Air permeability Class 2 – 12 m³/m²h at 50 Pa pressure.EN12428 Thermal transmittance – 3.4 W/m²k.Operation:- Electrical:Operating voltage: 230 V AC, 50/60 Hz.Fuse: 10 A.Brake: Non-reversible worm gear.Speed monitor: Electronic monitoring.Limit switch: Electronic via torque.Gears: Worm gear 1750 RPM yields approximately 24 rotations door shaft.Direct drive system.No special wall reinforcement necessary.Temperature range: -20°C to 60°C.Soft stop, soft start.Connection using "CEE plug" or lockable mains isolator.Maximum door weight 400 kg.- Control unit:Output 0.37 kW, input 230 V. Including control unit with standard actuator Up-Stop- Down. The door closes using dead-man controls.Operating speed 0.25 m/s, safety rating IP 55. If there is a power failure, the disengage device enables manual operation at any time.Radio remote control.Open (if open button is used during closing process - door immediately stops and opens completely).Automatic close (safety photo cell compulsory requirement).Door closes automatically after set period (4–60 seconds).Pull switch for opening function.External push-button, key switch.Door/ bridge interlock.Other requirements: External security cylinder lock set into the door panel.Internal security cylinder lock set into the door panel.Integral outward opening personnel door, complete with low profile threshold, self closer, satin anodised aluminium frame with mitred corners.Lever handles and cylinder lock (Euro cylinder).Micro switch to provide an interlock (electrically operated doors only). Ventilators.0Secured By Design

A glazed sectional overhead door, designed to be used when there is a need for light, exposure, or vision. Typical applications are show-rooms, fire stations, or other applications where optimal daylight inlet and/ or exposure possibilities are desirable.

The sectional door slides up under the roof when opened, allowing free space around the door opening and leaving it completely free.

The glazed sections are made of extruded, anodised or painted aluminium and are equipped with single or double acrylic windows (frosted or tinted) or hardened glass.

The frames are available in anodised aluminium as standard.

More about Crawford OH1042F Glazed Overhead Sectional Door:
As standard - Options - Approvals

Crawford OH1042F Glazed Overhead Sectional Door
 Manufacturer:
ASSA ABLOY Entrance Systems Ltd - Industrial.
  -Web:www.assaabloyentrance.co.uk.
  -Tel:+44 (0)333 006 3443.
  -Product reference:
Crawford OH1042F Glazed Overhead Sectional Door.
 Size:
[As drawing].
[As schedule].
 Track system:
[2 piece, galvanized tracks complete with 25 mm thermal movement provision].
[High Lift (HL)].
[Inclined roof tracks ].
[Low Lift (LL)].
[Standard Lift (SL)].
[Vertical Lift (VL)].
 Door panels:
  -Internal finish:
[Painted, RAL ???].
[Self aluminium].
  -External finish:
[PS 24W/ RAL 3002 Carmine Red].
[PS 28W/ RAL 1021 Rape Yellow].
[PS 20W/ RAL 5010 Gentian Blue].
[PS 38W/ RAL 7016 Anthracite Grey].
[PS 21W/ RAL 9010 Pure White].
[PS 23W/ RAL 9002 Off White].
[PS 25W/ RAL 9006 Metallic Silver].
[PS 29W/ RAL 6005 Moss Green].
[PS 43W/ RAL 9007 Grey Aluminium].
 Windows:
[DAS/DSS]. - Double glazed acrylic single sealed.
[DAD/DSD]. - Double glazed acrylic double sealed.
[TAD/DSD]. - Triple glazed acrylic double sealed.
[SA3]. - Single glazed acrylic pane 2,8 mm.
[SS3]. - Single glazed acrylic pane 2,8 mm.
[SH4]. - Single glazed hardened pane 4 mm.
 Infills:
[Aluminium sheets].
[Mill finished].
[Stucco embossed outside and inside].
 Operation:
[Electrical]. - 3-phase 230 V AC.
[Hoist and handchain type T]. - Chain hoist "T" (Gear ratio 1:4, Door weight maximum 250 kg).
[Hoist and handchain type U]. - Chain hoist "U" (Gear ratio 1:3, Door weight >250 kg).
[Pull down rope and lifting handle].
 Control unit:
[Not required].
[Required]. - Electrical operation, see ‘Options’ below and insert requirements.
 Other requirements:
[External security cylinder lock set into the door panel].
[Internal security cylinder lock set into the door panel].
[Integral outward opening personnel door, complete with self closer, satin anodised aluminium frame with mitred corners].
[Lever handles and cylinder lock (Euro cylinder)].
[Micro switch to provide an interlock (electrically operated doors only)].
[Ventilators].


top ^

Guidance

for Crawford OH1042F Glazed Overhead Sectional Door

from ASSA ABLOY Entrance Systems Ltd - Industrial

More about Crawford OH1042F Glazed Overhead Sectional Door: As standard - Options - Approvals

As standard

Size:

Maximum:7250 x 6050 mm. On request available up to 9000 x 6050 mm.

Arrangement:

  • Size (width x height): Insert details.
  • Shot blasted counterbalance springs, mounted on a galvanized, hexagonal shaft.
  • Spring and cable break anti-drop devices.
  • Flush hinges and roller brackets.
  • Inset lifting handle.
  • EPDM perimeter and horizontal joint seals.
  • Finger pinch protection to horizontal joints.

Door panels:

44 mm thick, 600 mm deep sections constructed from horizontal and vertical aluminium glazing bars.

Ironmongery:

Internal sliding shootbolt suitable for additional padlock with interlocked micro switch to prevent motor and door damage.

Performance:

  • EN 12424 Wind resistance Class 2 – minimum 700 N/m².
  • EN 12425 Water penetration Class 3 – 70 Pa resistance.
  • EN 12426 Air permeability Class 2 – 12 m³/m²h at 50 Pa pressure.
  • EN12428 Thermal transmittance – 3.4 W/m²k.

Options

Operation:

- Electrical:

  • Operating voltage: 230 V AC, 50/60 Hz.
  • Fuse: 10 A.
  • Brake: Non-reversible worm gear.
  • Speed monitor: Electronic monitoring.
  • Limit switch: Electronic via torque.
  • Gears: Worm gear 1750 RPM yields approximately 24 rotations door shaft.
  • Direct drive system.
  • No special wall reinforcement necessary.
  • Temperature range: -20°C to 60°C.
  • Soft stop, soft start.
  • Connection using "CEE plug" or lockable mains isolator.
  • Maximum door weight 400 kg.

- Control unit:

  • Output 0.37 kW, input 230 V. Including control unit with standard actuator Up-Stop- Down. The door closes using dead-man controls.
  • Operating speed 0.25 m/s, safety rating IP 55. If there is a power failure, the disengage device enables manual operation at any time.
  • Radio remote control.
  • Open (if open button is used during closing process - door immediately stops and opens completely).
  • Automatic close (safety photo cell compulsory requirement).
  • Door closes automatically after set period (4–60 seconds).
  • Pull switch for opening function.
  • External push-button, key switch.
  • Door/ bridge interlock.

Other requirements:

  • External security cylinder lock set into the door panel.
  • Internal security cylinder lock set into the door panel.
  • Integral outward opening personnel door, complete with low profile threshold, self closer, satin anodised aluminium frame with mitred corners.
  • Lever handles and cylinder lock (Euro cylinder).
  • Micro switch to provide an interlock (electrically operated doors only).
  • Ventilators.

Approvals

  • Secured By Design .

Further Information

Literature:

RIBA Product Selector

Additional information may be available for ASSA ABLOY Entrance Systems Ltd - Industrial from ribaproductselector.com.

Contacts:

www.assaabloyentrance.co.uk

sales.uk.crawford@assaabloy.com

T: +44 (0)333 006 3443

F: +44 (0)114 257 4399

Drag work item to add to schedule

top ^

 
NBS Plus
NBS Building, online library, 12 December 2017